Avaya 132-S-900.5 Exam - BestSheet.com

Free 132-S-900.5 Sample Questions:

1. You are developing IT Telephony bandwidth requirements for WAN traffic between two S87xx sites. The client estimates that simultaneous non-IP Telephony traffic will occupy 1.5 Mbps. In addition, they estimate that using G.729, 55 simultaneous IP calls need to be provided access to the WAN link.
What estimated bandwidth will the IP Telephony traffic add to the WAN traffic?
A. 1.5 Mbps
B. 275 Kbps
C. 1650 Kbps
D. 4675 Kbps
Answer: C

2. Which three site survey factors should be used to measure the contours of Radio Frequency (RF) coverage? (Choose three.)
A. link speed
B. signal strength
C. signal-to-noise ratio
D. obstructions in the Fresnel Zone
E. horizontal and vertical polarization
Answer: A, B, C

3. A company is upgrading their current G3R to an S87xx IP-Connect platform.
Which two cards will be added for system communications? (Choose two.)
A. DAL2 Card
B. IP Server Interface (IPSI)
C. Media Processor (MedPro)
D. Expansion Interface Card (EI)
Answer: B, C

4. Which three are QoS/CoS recommendations that the Avaya Solution Designer can make to optimize an all Avaya Converged IP Solution? (Choose three.)
A. Switched networks should use IEEE 802.1p/Q.
B. Routed networks should use DiffServ Code Points.
C. Port priority can also be used to enhance 802.1p/Q and DiffServ.
D. Mixed networks should choose only one (802.1p/Q or DSCP) as a best practice.
Answer: A, B, C

5. Your client is requesting a design that includes 750 IP Telephony endpoints, 75 digital endpoints, 45 analog endpoints and 5 ISDN PRI facilities. During the process you need to design the network regions with the client.
What information is needed to define the network regions? (Choose three.)
A. IP endpoints that are grouped geographically
B. IP endpoints that incorporate the same dial plan
C. IP endpoints included in communities of interest
D. IP endpoints using the same compression method
Answer: A, C, D

6. Your customer solution calls for converging an existing 10/100 network with a mix of TDM and IP endpoint resources. The customer requirements call for end-to-end QoS and you have recommended using DiffServ Code Points to 802.1p priority values so 802.1p tags can be recreated on each Ethernet link.
Which 802.1 priority value is used to support delay sensitive voice traffic?
A. 000
B. 101
C. 110
D. 111
Answer: C

7. To improve resiliency and increase fault tolerance in a LAN environment, you recommend implementing Link Aggregation Groups (LAGs).
Which form of fault tolerance does LAGs provide?
A. multiple routing paths
B. multiple active uplinks
C. redundant spanning tree
D. redundant switching fabric
Answer: B

8. A customer has an S8500 Server with 500 IP phones.
If they want to implement end-to-end QoS, which three need to be enabled on the Server and the IP phones? (Choose three.)
A. 802.1p
B. VLAN tagging
C. UDP port 1719
D. Differentiated Service
Answer: A, B, D

9. Given a migration from Definity Server R, release 10, to Communication Manager 4.0, which of the following is not supported?
A. BX.25
B. ISDN-BRI
C. Fractional DS1
D. TN1654 E1 mode
Answer: A

10. What is the maximum number of TN2602 IP Media Resource circuit packs allowed in a port network?
A. 1
B. 2
C. 3
D. 4
Answer: B